Maserati Forum banner

06 GrandSport Coupe Crank, no start.

1 reading
2.6K views 11 replies 4 participants last post by  02.4200.gt  
#1 ·
Hello Maserati Fam,
I picked up an 06 Maserati Grandsport in efforts to save. No Crank, No start, seats inop, windows inop.

Here's what I've done so far.
Brand new battery 48/H6 series Battery
Checked all fuses/Relay from front to back
Battery Reset procedure
Replaced Starter (bad solenoid)
Yes F1 pump kicks on
Fuel pressure on both rails
I have a snap on scanner, in OBD2 mode I pulled up data to check CMP signal, Nada.
I do have the CODE light while cranking(stays solid) don't have the 5 digit code to bypass yet, Calling Maserati tomorrow.

Looking for any tips/advice to save this car. Thank you in advance!
 
#2 ·
That sounds like a immobilizer issue..You should have a code in your ECM if it is..I want to say P1562 off the top of my head...Jason
 
#7 ·
Swapping the NIT on a GT may cause all sorts of issues but CODE shouldn't be one of them, unless it was changed with the updated infotainment, about which I have no idea.

C
 
#11 ·
@02.4200.gt Did I ask your opinion on what you'd do? this site is for networking. if this post helps people diag their car without having to spend a ton of money, why not? So go troll somewhere else, BTW the car started today thanks to @Jason@ Enzo`s Atlanta tip about the ECU.

So to fix my starting issue I will need a new key, I've never saw a RFID chip turn into saw dust. You can do a override if you have the CODE card. I didn't have one and was able to call a dealer and order one(you just need proof of ownership).
Thanks to everyone who posted.