Maserati Forum banner
1 - 1 of 1 Posts

· Registered
42 Posts
Discussion Starter · #1 ·
not sure if anyone has had this before. On the rear window of my Coupe the rubber trim (or some sort of material) which seals the window has disintergrated in one place. Can this be replaced at all without having to replace the whole window by some specialist?

On closer inspection the trim seems to be a single layer, and doesn't actually seem to be holding the window in place, it looks like it's job is to prevent anything from getting inside the fixture. I has hoping that it would be possible to pull of this trim, get a new one and stick it back on again....probably far too simple.

any ideas?

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.