Can you feel the groves or are they just visual?

If you can feel them, then something is very wrong.

 

I can feel them slightly. I did bed the pads

 

Looks like every set of discs I've ever had.

C

 

I would not be as concerned except my wife has same car and the dealer replaced her front rotors same as mine and new pads. Her rotors do not show these groves . Only difference is her pads are the newest pert number 673012383 and mine are about two previous part numbers back 673012041.
I will say when I looked at these pads Before I put them on the pad material looked a bit textured like stone not smooth like other brake pads I have had , no damage they were in brembo packaging Maserati box. I looked up other pads same part number online and they also had same texture so I assumed this how they’re supposed to be. I’m wondering if this is the difference between mine and my wife’s rotors ?

 

Personally, I've never seen only 500 miles looking like that!

 

The pads looked like grinding stones. Have you guys ever seen a pad surface like that

 

I just ordered a set of EBC DP42355R yellow pad. The oem pad current part number is like $600. I’ll get the rotors turned and try that out . I’m thinking the pads I got were about two part numbers back from current pad and probably replaced due to eating up rotors. The part number for the rotors has not changed since first model

 

All right, I pulled the pads out on the side. That’s the worst. The other side is not as bad and you can see like they’ve got like copper or some kind of metal in there. I guess these are just supposedly very abrasive pads. Any thoughts?

 

I would change out the pads, bed 'em in and if it stops smoothly, I would drive on.

 

Can these rotors be cut, turned ?

 

Why? You're really overthinking this, I'm afraid.

C

 

Not many shops are setup to turn a drilled rotor. While they look bad they are not exactly bad, as long as they are not warped and the pad is not wiped out just run them.

 

Found a Napa local that’s turning the rotors for me let’s see how they turn out

 

They should smooth right up, to your liking...just make sure you have min. thickness. 👍