Some might not like this, but I found it to be stunning. Its one of those interiors that you have no clue how good it looks until you see it. You just can't order this on paper and think it will turn out this good.
Phil
8)
Phil
8)
GranSport interior-grigio nickel fabric w light gray leather
1 - 3 of 3 Posts
more.....
Attachments
1 - 3 of 3 Posts
Join the discussion
Recommended Reading
-
Maserati 4200 production numbers
Coupe, Spyder, GSSomeone on Ferrarichat posted a link with Maserati 4200 production numbers. The Spyder is alot rarer than the coupe. Also Spyder 6 speed GT's are super rare as many have said with only 574 being made, along with GranSport Spyder Cambiocorsa's with 472 being made. Variant special editions are the...- 66
- 19K
-
Need help with Gas leak somewhere
Coupe, Spyder, GSGas smell on passenger side, 2004 Spyder had it on the lift, no drips whatsoever, anywhere on the underside, none in the engine compartment.. Anyone have any experience with this, can I go through the top end, remove the interior and see whats happening?- 5
- 158
-
Looking for KW tuning tips
Coupe, Spyder, GSI just got a set of V3's installed, and am wondering if anyone remembers the damping settings that they ended up with as optimal? I know everyone has different preferences and needs. I have put a few miles on the new setup now, and have some ideas about what I want to change, but I'm mainly...- 0
- 69
-
Replaceing Oval Fender Emblems on Gransport LE
Coupe, Spyder, GSJust an FYI for future refence. You will find past posts where people suggest drilling out the center to replace this emblem. Don't do that!!!! First of all it's a Maserati (Don't drill anything) and secondly, these emblems are quite heavy, too heavy for just double sided tape. It is time...- 1
- 92
-
Fix for top hydraulic line
Coupe, Spyder, GSHad to repair one of the hydraulic lines that had sprung a leak on my 2002 Spyder. When assembled the line was crushed by a nylon tie that Luigi made too tight. With the line flattened and with the flexing caused by the cylinder having to rotate around 90 degrees (cylinder for rear arch) the...- 0
- 77
Join now to ask and comment!