Maserati Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
160 Posts
I had some problem on the door wire harness connector which is on the A-pillar. The rubber weather seal around the male connector (the end coming out of the door) is not seated properly to create a perfect seal.

So I am guessing; when you were doing the car wash, there might be excess water getting into the connector and shorted something. When the connector is dried up, the door started to work again.

I discovered the this fault when I was gently pulling on the wire harness. You can give it a gentle pull to see if it make your door unlock/lock intermittently.

Mine was so bad, that when the door is open, I couldn't get the door mirror to work correctly. I pressed the memory key, the seat moved to position, but the mirror would stuck on the ground-looking position.
 
1 - 1 of 1 Posts
Top