[tommyfromla]

Ok so I got a new clutch about 2 months ago I started driving the car and it tends to go in neutral out of nowhere alot now usually when I come to a brief stop or even sometimes while driving. What can this be?? Do they always need to get tuned with the computer? Its really annoying I thought it was the clutch sensor so I had this changed again but it didnt do anything. Let me know if you guys know anything about this.

 

[fade2grey]

sounds like it's not been calibrated correctly. When fitting a new clutch they need to be setup on the computer. Get em to do it again & all should be well - if it's a sensor the SD2/3 which does the calibration should register a code for that I'm guessing.

 

[Tutti]

It sounds like it can use a self learn or maybe the pis is out of range. also I have had the same problem with the clutch being replaced but not bleeding the f1 system.

 

[BigA3723]

I think this can also be caused by F1 fluid being too low. Check fluid level

 

[GCalo]

It is either low fluid as stated or the PIS needs to be reset.

Sometimes w/new clutch disc the computer does not accurately sense the disk.

After a few hundred miles it's good to have it recheched and reset with SD2/SD3

 

[Victory12]

Tommy,
It sounds like a cycle test was never performed. The cycle test does not only reset the pis and the "new closed clutch Position" but the TCU also.
Best of Luck!
Ciao
[email protected]