Maserati Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
74 Posts
Discussion Starter #1
Well, it's only been about 5 weeks since I got the car and it is going into the shop for a second time. This time the cambio didn't release when I came to a stop, just like if you left a manual in first and stepped on the brake. Jerked forward and then stalled. On startup there there was a loud whining from the trans. but the car worked ok, within a block the noise went away. Could it be the TO bearing? - Any thoughts.
 

·
Registered
Joined
·
824 Posts
My car (05 CC) has stalled once too, coming up to a stop.

I think Maserati should have a :oops: icon on the dash for when the Cambiocorsa messes up.

Mine also flashed the red gearbox warning light the other day briefly, I put it in neutral and had to roll back for a few feet. Dunno why, it has been fine since.

Glenn
 

·
Registered
Joined
·
74 Posts
Discussion Starter #3
The car has been in the shop for the last week. At least at this point they believe that the stalling and not disengaging from 1st is a software problem and they are adjusting it. I'll see what happens when I get it back.
 
1 - 3 of 3 Posts
Top